[admin]

Feather-Loc® is the first-ever multi-purpose featherboard for your router table, router fence and rip fence. It's also the first featherboard to include an easy-set feature. Simply place your wood under the set-up guide and tighten the knobs! Feather-Locs® can also be incorporated into most 3/8" X 3/4" T-slot track systems. Twin Feather-Loc® does not include miter bar slot adapter.
Customer Review: Good but could be better
This featherboard does a pretty good job. I use it mostly on a Bosch 4000 Table Saw. The fingers hold the workpiece OK and do not seem prone to breaking. Slight problem: Only one of the locking bolts spreads out the shoe in the miter slot, and it does not grip very well. It takes a lot of tightening to get a grip. To help it along, I glued small bits of sandpaper on the shoe, where it spreads out inside the miter slot. That makes it easier to anchor down without over-tightening the knob.
Customer Review: Awsome
Used my newly purchased Bench Dog featherboard for the first time this past week-end. Used it on my Bench Dog router table. Only complaint I have is that of the two 'studs', one was the regulat T-Slot base, which worked fine. The other had a semi-circular base which would NOT fit the T-Slots on my table, making it unusable. You would think that a Bench Dog Featherboard would fit a Bench Dog Router table in all respects, but in this case, it dosen't. Other than that, I found the board extremely helpful in that I was routing on very narrow stock. The board did hold the stock firmly against the backboard, was easy to set up and maintained its' position even with only the one T-Bolt in use. I would rate this a "5" if both studs were of the T-Bolt style. Now I've got to find a T-Bolt to replace the mushroom based one to make it fully usable.


More...